![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]() I am in the process of wiring a Garmin 496 into my 182, using the Garmin supplied accessory data cable. After reading about all of the problems with the 396 496 Data Cable connectors coming apart, I cut the cable to about a foot, installed a male DB9 connector on the cable, and the matching DB9 female in the aircraft. This way, future replacement becomes simple. This enables you to discard most of the pis*-poor thermoplastic insulated wires, which are way too small in terms of current carrying capacity, anyway. This way, all of the wiring under the panel can be done with proper Tefzel ms aircraft wire, which should make your inspector happy. The power leads can be properly sized (24awg), the audio can be shielded, the RS232 data lines can be shielded, etc. This minimizes the ground drop along the Garmin Data cable ground wire, so you may not have to use a "ground-loop-isolator" to get rid of the whine in the stereo feed, as a lot of folks have had to do. Also, in the event of a Garmin connector failure, you can make a new interface cable at home, starting with a new cable from Garmin and a new DB9 male, without ever having to stick your head under the panel of the airplane! You can even carry a spare, and change it "on the fly" (pun intended). I'm suggesting that this be adopted as a "standard", so all of us that use Garmin 396/496 portables in our aircraft can be "interoperable". Here is the wiring that I'm using and proposing: __________________________________________________ ____ GARMIN 396/496 DATA INTERFACE CONNECTOR WIRING (Using Garmin 010-10513-00 Power/data cable and hooded Male DB-9 connector) MGM Oct 24, 2006 Pin#.Color..Description ------------------------------------------ 1....Blk....DC input 2....Wht...Alarm (active low) 3....Brn....Voice+ (Bitch in the box) 4....Blu....Port 1 RS232 Out 5....Vio....Port 2 RS232 Out 6....Blk....Common ground 7....Org...Voice- (Bitch in the box) 8....Yel....Port 1 RS232 In 9....Grn....Port 2 RS232 In Please disseminate this as widely as possible. Mike Mladejovsky __________________________________________________ ______ |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Garmin 396 496 Data Connector Wiring Standard | mikem | Owning | 3 | October 25th 06 04:40 AM |
Garmin GpsMap 396 - First Impressions (long) | Mike Spera | Owning | 23 | July 3rd 06 09:57 PM |
Amateur Review of the Garmin GPSMAP 296 GPS | Rhett | Piloting | 10 | March 23rd 05 01:16 AM |
Need help with Garmin 196 data transfer (long) | RNR | Piloting | 7 | March 17th 05 07:37 AM |
Pirep: Garmin GPSMAP 296 versus 295. (very long) | Jon Woellhaf | Piloting | 12 | September 4th 04 11:55 PM |