|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
November 20th 06, 06:24 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
I've had it with Chinese tools!
"Juan Jimenez" wrote in message
.. . Check Sears. Their website shows an SK pair for $84.99, or Craftsman 6 and 9 inch for $99.99. Each, or for the pair? For the pair. I can't find them seperately though. The SW pliers I bought suck because the tips don't even meet when you tighten your grip. Part of it is my fault for not paying good attention when I bought them. Not familiar with SW. But if they have a lifetime guarantee, return them saying they bent. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| China Develops Stealth Fighter - J-14 | Mike | Naval Aviation | 1 | June 25th 06 04:12 PM |
| VQ-1's P4M-1Q crash off China - 1956 | Mike | Naval Aviation | 0 | May 6th 06 11:13 PM |
| EAA Chapte Tools | [email protected] | Home Built | 7 | March 8th 04 10:51 PM |
| Why do you buy Snap-on tools? | Anonymo421 | Home Built | 12 | November 9th 03 09:40 AM |
Threaded Mode