|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 28th 06, 12:33 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Etching copper clad
Getting ferric chloride from Radio Shack is getting problematic. Is
there a common household chemical that I can use for etching a circuit board or two? I seem to remember Jim Weir having an article about how to do it in the not to distant past, but I can't find anything about it in my back copies of Kitplanes. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Copper in oil analysis ? | [email protected] | Owning | 8 | August 22nd 06 12:31 PM |
| Copper in oil analysis ? | [email protected] | Instrument Flight Rules | 8 | August 22nd 06 12:31 PM |
| high copper reading in oil analysis | [email protected] | Owning | 1 | March 26th 04 03:32 PM |
Threaded Mode