|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 1st 07, 07:55 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Sealant for polyethylene fuel tank?
I'm looking for a sealant or kit to seal brass NPT inserts into a
polyethylene tank. This is a Kitfox header tank that has developed a leak at one of the inserts. I'm probably going to use Mogas that has ethanol additives. Any hints, tips, thoughts? Thanks, Rob 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel tank balance | Mxsmanic | Piloting | 101 | October 3rd 06 08:56 AM |
| Anyone had fuel tank air vent icing up? | Jim Macklin | Instrument Flight Rules | 3 | February 28th 06 10:57 PM |
| fuel tank plumbing | pwm | Home Built | 18 | January 27th 05 05:54 AM |
| Fuel line thread sealant | Paul Lee | Home Built | 7 | February 26th 04 01:44 AM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 03:57 AM |
Threaded Mode