|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
March 2nd 07, 01:32 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Sealant for polyethylene fuel tank?
On Thu, 01 Mar 2007 20:37:38 GMT, Dennis Fetters
wrote: wrote: On Mar 1, 12:55 am, "Rob Turk" wrote: I'm looking for a sealant or kit to seal brass NPT inserts into a polyethylene tank. This is a Kitfox header tank that has developed a leak at one of the inserts. I'm probably going to use Mogas that has ethanol additives. Any hints, tips, thoughts? Thanks, Rob Red high temperature silicon sealer. Local hardware store. Clean the threads with alcohol and apply sealer. Lasts forever. Except RTV is NOT gasoline resistant. -- Posted via a free Usenet account from http://www.teranews.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel tank balance | Mxsmanic | Piloting | 101 | October 3rd 06 07:56 AM |
| Anyone had fuel tank air vent icing up? | Jim Macklin | Instrument Flight Rules | 3 | February 28th 06 09:57 PM |
| fuel tank plumbing | pwm | Home Built | 18 | January 27th 05 04:54 AM |
| Fuel line thread sealant | Paul Lee | Home Built | 7 | February 26th 04 12:44 AM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 02:57 AM |
Threaded Mode