|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 5th 07, 04:01 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Bending longeron
I need to make bends of about 30 degrees in a 3/4 x .049 longeron tube,
with a tight bend radius, no more than 3 inches. Can I do the bend hot without wrinkling the tube by free bending or do I need a supporting die of some kind? Anybody have any specific techniques? John 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bending graphlite rod | [email protected] | Home Built | 15 | July 25th 06 06:43 AM |
| Bending sheet stock | Michael Horowitz | Restoration | 1 | April 24th 06 04:28 AM |
| Wing Bending Oscillation | jcarlyle | Soaring | 18 | February 21st 06 04:37 PM |
| Bending extruded angle | Veeduber | Home Built | 8 | August 29th 04 12:58 AM |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 06:15 PM |
Threaded Mode