|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 9th 07, 07:06 AM
posted to rec.aviation.soaring
|
|||
|
|||
Cobra trailer gas spring
I have an early 1990's vintage Cobra trailer with a front hatch. The gas
spring that holds the hatch up has deteriorated, and I'd like to replace it. I've emailed both Cobra and the German gas spring manufacturer with no response. I can see that the length of the gas spring is critical to the operation of the door, but I can't tell what the correct pressure is from any markings on the device. Does anyone know of a US source for a comparable part and what the resistance should be? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra Trailer | [email protected] | Soaring | 22 | December 7th 06 11:38 PM |
| Cobra trailer trim. | Bob | Soaring | 12 | July 19th 06 05:12 AM |
| Cobra Trailer For Sale (15 m) | Albert Gold | Soaring | 0 | October 7th 03 09:00 PM |
| Cobra Trailer | Soaring | 1 | September 28th 03 01:14 PM | |
| FS: Cobra Trailer | Ed Byars | Soaring | 0 | September 22nd 03 04:47 PM |
Threaded Mode