![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Has anyone done calculations for takeoff distances for various density
altitudes, weights and winds for their sailplane-towplane combination? Every powered plane POH has a table but there are none in the glider books for obvious reasons (HP of towplane for one). The Arizona Soaring Assn flies out of some high (6600') and short (3900') runways (not concurrently) and in our typical conditions would like to fly with ballast but are revisting the idea that we should limit weights after some long takeoff rolls and/or slow climbs. We usually do not have good bail out options at most of our fields for rope breaks as an added issue. Casey Lenox Phoenix KC |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
measuring arm distances | Heino & Deanne Weisberg | Home Built | 1 | October 21st 05 05:49 PM |
Stuck at work--need takeoff/landing distances for a 172 please | Yossarian | Piloting | 12 | July 14th 05 01:12 PM |
Edge distances in steel | Ed Wischmeyer | Home Built | 3 | August 24th 04 10:53 PM |
Are sectional paths correct across "long" distances? | vincent p. norris | General Aviation | 32 | March 25th 04 02:32 PM |
Are sectional paths correct across "long" distances? | vincent p. norris | Piloting | 36 | March 25th 04 02:32 PM |