|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
September 16th 03, 07:50 AM
|
|||
|
|||
If you want cad templates, for pete sake, draw them up and save them
as templates. If you want pretty pictures, scan magazine photos into a graphics file and load the bitmap into your CAD program as an image. Woiks fer me, anyway. Don't forget to look "behind" the panel for obstructions and other headaches that always ruin the perfect panel layout. -- Richard Lamb http://www.flash.net/~lamb01/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| All I Wanted For Christmas Were Inverted Spins | [email protected] | Aerobatics | 3 | December 29th 04 07:40 PM |
| Wanted an Alon | Joe Spencer | Home Built | 1 | September 1st 03 07:44 PM |
| Vans RV4 or RV6 wanted | Joe | Home Built | 0 | August 17th 03 01:02 PM |
| Murphy Rebel Wanted | Joe | Home Built | 0 | July 8th 03 06:21 AM |
| Used Bing 54 Carbs wanted | Ed Baker | Home Built | 0 | July 4th 03 12:41 PM |
Threaded Mode