![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
![]() "Rich S." wrote in message ... "wmbjk" wrote in message ... "Rich S." wrote in message ... 4-1/2 HP 21 GALLON CAST IRON VERTICAL COMPRESSOR 4-1/2 peak horsepower; 120 volt, 60Hz chuckle Wayne Can't be any good, 'cuz it don't cost enough - right? Not at all. I was just chuckling about the 4.5 hp on 120 part. I've got a shop full of HF stuff, and I resent it when the tool bigots make fun of that equipment. Making fun of my low budget tools is *my* job. :-) I checked on the compressor link you posted. Seems like a good deal, and should be fine for most projects. Output is too small for much painting though. Wayne |
Thread Tools | |
Display Modes | |
|
|