![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I had thought a chandelle was really half a loop followed by a half
roll to get right side up, but most describe it as a climbing turn (almost like a wing over?). It was a long time ago, but I seem to remember being in an Aerobat and started a loop by diving and getting to maybe 140 kts before the pilot pulled back. The question nagging at me is, if in something like an Arrrow or a Mooney, if you were in a cruise at 140 knots would you have enough speed to pull back into a half loop to make a fast 180 degree change in turn in a tight space? I suppose I could calculate if one maintained 2 gs worth of backpressure what would happen (it would be a funny half loop, turn radius would get tighter and tighter as speed decreases and gravity started pulling at the tail instead of at the wheels, but real life experience is better than calculations, if anyone has such experience. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
F-15C in a tight turn | Tom Callahan | Aviation Photos | 1 | April 16th 07 06:58 PM |
Question: Standard rate turns, constant rate turns, and airspeed | Robert Barker | Piloting | 5 | April 15th 07 04:47 PM |
Tight Screw Causes Sea King Crash | Shiver Me Timbers | Rotorcraft | 0 | August 30th 04 04:12 PM |
Fly tight for tight bomb patterns on the ground. | ArtKramr | Military Aviation | 120 | August 30th 04 08:42 AM |
Tight patterns? | Bob Martin | Piloting | 51 | January 26th 04 08:42 AM |