![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
|
|||
|
|||
|
flyer wrote:
I inadvertently did not return the ignition switch to "BOTH" after a preflght mag check cause: distraction, I was an idiot) the other day departing in my Glasair with my partner. The engine is a 150hp O-320-E2D. The engine only developed 1900 rpm (2200 is normal for us on 2 mags with fixed pitch prop) and climbed poorly and ran rough. After figuring it out in approximately 1 minute, I switch back to "BOTH" and everything was fine. That was a few months ago. Our recent annual showed some low compression in #3 (55) and the others were in the mid 60s, down a few points from last year. Not what I would like but the engine runs strong. My partner said that the single mag takeoff could have caused "detonation" or "cylinder glazing" or "a bad flame front in the cylinders" and ruined the compression. I don't think that at that low power setting in a 7:1 compression engine anything bad could happen. I am not aware of anything bad that could happen in general from single mag operation at any power setting, other than rough performance. This would be the same thing as having a fouled plug in a cylinder, and nothing bad happens then. Does anyone have any other feelings about this phenomenon. I dunno. I am not a mechanic, and haven't flown in a long time. However, the two most probable problems are that you could foul the plugs associated with the inoperative magneto and that you would have the effect of a slightly retarded spark--increased head temperature and egt and very slightly reduced power. The real risk would be the lack of any automatic redundancy in the event the the operating magneto shold fail. The short answer is that you probably didn't hurt it any more on one mag than I did climbing out with the carb heat on after a touch and go. Try not to make my second, and much more dissastrous mistake as well: After about the third time in two months that I forgot to turn off the carb heat on a touch-and-go, I got the idea that about a two month break from flying would enable me to forget the bad habbits which I had developed and resume the proper and efficient use of my checklist. The dissastrous result was that two months became three and three became six and ... and I currently hope to put flying into next year's budget. What makes that bad decision so bad is that it happened in 1983! :-( |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2004 California airshow schedule taking shape! | Wings Of Fury | Aerobatics | 0 | December 31st 03 06:32 AM |
| DK-1 All Metal single seat biplane | Michael | Home Built | 0 | July 28th 03 06:16 PM |