![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#37
|
|||
|
|||
![]()
Maxwell wrote:
If you didn't go with a continuous wire, wouldn't you be gambling on a possible arc between links? The sash chain I'm familiar with has small, very tight links. It's almost like an extra flexible bicycle chain. Personally, I use a wire, because I have it. As for the chain, you have a point, but I'd have to think conditions would have to be so perfect... |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Temporarily removing fuel and replacing it into the same aircraft | B A R R Y[_2_] | Piloting | 39 | August 2nd 07 04:30 AM |
Removing 100LL Fuel Stain | Jeff | Home Built | 7 | September 20th 05 08:45 PM |
FOLO: Replacing fuel cut-off valve with non-a/c part??? | Michael Horowitz | Owning | 10 | February 23rd 05 04:35 AM |
Fuel quality control standards for aircraft rental/fuel sales... | [email protected] | Owning | 19 | January 19th 05 04:12 AM |
Replacing fuel cut-off valve with non-a/c part??? | Michael Horowitz | Owning | 46 | January 15th 05 10:20 PM |