![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
We just recently tore into an engine that had been sloppily cowled in an
experimental airplane. The bottom was fine but the top was cooked. Cylinders, you could tell, had been fried, most likely because they had not been baffled and cowled properly. Pistons, valves, cylinder walls, rings, guides, seats --- all looked like they had been through hell. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Speaking about Sonerai's................ | Vincent Vega | Home Built | 4 | September 15th 03 10:16 PM |
Surface radiators for water cooled engines | Harry Burns | Home Built | 65 | July 22nd 03 05:45 PM |
oil cooling | [email protected] | Home Built | 2 | July 11th 03 02:15 AM |