|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 27th 07, 05:39 PM
posted to rec.aviation.soaring
|
|||
|
|||
Panel Materials
I am getting ready to replace the panel in my Ventus B. Are there any
standard materials (especially the core) and recommended glass and core thickness used to layup a new one? This is a fixed panel, does not pop up when the canopy is opened. I was thinking of using a 1/16" to 1/8" core of DIVINYCELL. So far the thinest I can find is 1/8", is this too thick and will it handle the compression of mounting screws through it? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Grounded - Where to get rid of the Building Materials? | Rocketeer | Home Built | 49 | July 22nd 06 11:43 PM |
| CFI training materials | Steven Barnes | Piloting | 6 | May 8th 06 03:20 PM |
| CANADIAN IFR TRAINING MATERIALS | [email protected] | Instrument Flight Rules | 1 | January 29th 05 11:51 AM |
| Instrument training materials | Paul Folbrecht | Instrument Flight Rules | 3 | July 15th 04 06:01 PM |
| Mixing construction materials | Neal Fulco | Home Built | 3 | October 7th 03 01:55 PM |
Threaded Mode