![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
Andy wrote:
On Oct 30, 12:42 pm, wrote: On Oct 30, 1:49 am, "Bert Willing" bw_no_spam_ple...@tango- On this (aborted) launch, I was still rolling, both wheels on the ground. I noted the chute opening in front of other gliders too, while on the ground. I'd had no problems launching with our non- chuted poly rope. How springy is 3000 feet of spectra? I imagine that would be more of a factor for auto tow than winch. I'm speculating that the problem with the spectra launch is not the parachute itself but the dynamics of the rope tension. The result may be strongly dependant on how the tow vehicle accelerarates to nominal launch speed. Andy That makes senses. My guess would be that the tow vehicle changed gear and thus briefly reduced power, which would probably be enough to allow the chute to start to open. Some automatic gearboxes have quite a deliberate gear change, enough to reduce the tension on the rope. If there's a lot of spring in the rope a gear change could set up some brief oscillation, enough to allow the chute to flap around. Did it close again, or remain open? If the latter, either the tow vehicle wasn't pulling or there's something very odd about the chute design. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Buy and Sell Ground Support Equipment | knowmad | Piloting | 0 | September 29th 05 07:46 PM |
Used Ground Support Equipment | knowmad | Aviation Marketplace | 0 | September 29th 05 07:33 PM |
Let's talk ground launching........ | Rusty | Soaring | 23 | September 4th 05 10:59 PM |
Let's talk ground launching..... | Steve Leonard | Soaring | 0 | September 2nd 05 11:48 PM |
From the ground up ... question about riveting | Marco Rispoli | Home Built | 4 | July 19th 04 01:05 AM |