|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
November 8th 07, 03:37 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Metal cutting bandsaw problem
Maxwell wrote:
Stationary brushes are ok, but the rotary a lot more robust and run longer without adjustment. Thanks guys, I'm going to look into these suggestions. Tony 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PLEASE NEED HELP with Cherokee 180 metal bulkhead problem under back seat | C | Owning | 37 | April 27th 05 02:00 PM |
| Cutting Lexan? | Scott | Home Built | 15 | February 19th 04 12:51 AM |
| Cutting shirttails??? | Larry Dighera | Soaring | 11 | September 3rd 03 03:34 PM |
| Cutting off shirt tails | Wally Samuelson | Military Aviation | 24 | September 3rd 03 12:33 AM |
| Cutting shirttails??? | Larry Dighera | Piloting | 1 | August 26th 03 06:55 PM |
Threaded Mode