|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#18
December 16th 07, 03:00 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Engine configuration
In article ,
Richard Riley wrote: On Fri, 14 Dec 2007 22:32:42 -0800, Steve Hix wrote: I spoke about an Indian motorcycle (in reply to the comment "that ought to bring out the Harley guys"). Guess those bikes were before most of the times for many in this group  )Big John Until a year or two ago, they were making them new down the road in Gilroy, CA. Too bad they couldn't make a go of it. They are reincarnating again http://www.indianmotorcycle.com/Port...dian%20Motorcy cle%20Revised%20Press%20Release%20-%20Revised%20Sept.pdf Factory in North Carolina, major stockholder is Stellican Limited, which brought back ChrisCraft. I wish them luck this go 'round. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| R172K Approach Configuration | facpi | Instrument Flight Rules | 10 | January 5th 07 03:58 PM |
| V-22 Prop Configuration, 3-vs-4 blades | Don McIntyre | Naval Aviation | 23 | April 10th 06 03:23 AM |
| T-2C Buckeye nav light configuration. | Mike W. | Naval Aviation | 14 | March 17th 05 07:05 AM |
| Question about center-line push-pull engine configuration | Shin Gou | Home Built | 4 | June 7th 04 05:57 PM |
| Hyping the Intermeshing Configuration | Dave Jackson | Rotorcraft | 0 | October 31st 03 08:34 PM |
Threaded Mode