|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 31st 07, 12:21 PM
posted to rec.aviation.owning
|
|||
|
|||
Removing an ELT to change battery
I have a Piper Archer III and want to change the battery. The ELT is
an Artex 110-4. I can open the panel and found two thumbscrews which only remove the cap of the ELT, I can also remove the BNC and Molex connector. There are four screws on top, however these serve only to open the ELT, exposing the circuit board, they do not allow it to be removed from plane. However, I can't remove the ELT itself from the plane to change the battery. It can't be hard, but it's not obvious either. Any ideas ? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removing RTV | John | Home Built | 6 | October 31st 06 10:07 PM |
| Removing the coatings? | Michael Horowitz | Home Built | 1 | October 8th 05 09:32 PM |
| Removing Fabric | Michael Horowitz | Home Built | 3 | August 15th 05 11:25 AM |
| [igc-discuss] To change or not to change... rules ? | Denis | Soaring | 0 | February 16th 05 07:24 PM |
| Removing old antennas | Jay Honeck | Owning | 30 | March 21st 04 04:34 PM |
Threaded Mode