![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I want to build a cable to run my M1 & M3 at home in demo mode. Both
navigators use the same connector & pinout for their power (connector P15 on M3, not sure about M1). The connector looks like a Centronics 24-pin, but the edges are more rounded. I showed my local electronic store my M3 but they have no idea of the type. Thanks in advance for any help. Robin Hou |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Northstar M3 & PC connection | [email protected] | Piloting | 1 | December 30th 07 04:56 PM |
Northstar M3 & PC connection | [email protected] | Instrument Flight Rules | 1 | December 30th 07 04:56 PM |
Northstar web page? | Brinks | Owning | 2 | January 27th 05 07:16 PM |
Need Help with Northstar M1 Loran | Jerald Malin | Owning | 4 | December 8th 03 05:38 PM |
WTB: Northstar M3 GPS | Bill Zaleski | Aviation Marketplace | 0 | October 29th 03 11:10 AM |