![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
There's a picture of the type of rocket used in the attack on the
al-Rashid hotel where Wolfowitz was staying: http://media.washingtonpost.com/wp-s...p10-26-03a.jpg Just from the picture you can tell that the length to diameter ratio of the rocket is 11:1. It's known that the "aluminum tubes" of centrifuge infamy had the dimensions 81 x 900 mm, which matches the size of the pictured rocket quite well. It's generally accepted now that those tubes where actually intended for helicopter fired rocket casings. http://www.isis-online.org/publicati.../al_tubes.html It's not a huge jump from the data to conclude that the rockets used in yesterday's attack where in fact the knock offs of the Italian Medusa-81 that Iraq was producing. It's a dark piece of irony, but you have to assume that it was known that Wolfowitz was in the hotel and the rocket was specifically chosen to reopen old wounds and cause Wolfowitz some political discomfiture. -- Robb McLeod ) A bus station is where a bus stops. A train station is where a train stops. On my desk I have a work station... |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
epoxy aircraft seats? | Lpmcatee356 | Home Built | 26 | December 3rd 03 11:16 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 02:46 PM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 05:23 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 03:52 AM |
Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 06:24 AM |