|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 5th 08, 03:03 AM
posted to rec.aviation.owning, rec.aviation.homebuilt
|
|||
|
|||
PC power using aircraft ground
I run a Motion LS800 for my EFB. I use a DC 12V to 19V power
converter to power my LS800 since I have a 12V aircraft system. To minimize the number of wires, can I use a single wire to run +19V from the power converter to LS800 and connect the ground from power converter to LS800 thru the airfram ground? Thanks in advance, Robin Hou 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PC power using aircraft ground | [email protected] | Owning | 5 | February 6th 08 03:43 AM |
| FS: 60' Aircraft ground power cable, 6-conductor, copper - $480 | [email protected] | Aviation Marketplace | 0 | May 16th 06 02:55 AM |
| Permit to use aircraft radio frequencies on ground | C. J. Clegg | Restoration | 1 | January 1st 05 11:08 PM |
| Propeller for aircraft engine ground test | Guy Deraspe | Home Built | 0 | July 21st 04 05:41 AM |
| Predicting ground effects on induced power | Marc Shorten | Soaring | 0 | October 28th 03 12:18 PM |
Threaded Mode