![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I have a sticky main strut in my Pa-28-151. My engineer has suggested
changing the o-rings and valves of both struts. I was curious about the whole structure and have looked everywhere in the internet with no luck Any suggestions where I could find them? Gus |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oleo Struts | xerxes | Owning | 4 | September 7th 06 04:54 AM |
Cessna Struts | jls | Home Built | 7 | July 16th 05 03:26 PM |
Gas Struts for Clamshell Trailer | [email protected] | Soaring | 1 | April 26th 05 02:49 AM |
172 Nosewheel Struts Leak Nitrogen | jls | Owning | 4 | April 9th 04 06:28 PM |
Regulator/valve for filling struts | Ben Jackson | Owning | 5 | January 24th 04 03:12 AM |