|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 14th 08, 01:11 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Sanding of plywood before epoxy
Sanding beaks the fibers producing a less strong lap joint.
So what if you use good one side plywood - is the lap joint going to be weaker because it is sanded? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sanding Glider Wing | [email protected] | Soaring | 1 | February 11th 07 01:37 PM |
| Sanding or Waxing - PIK 20 Question | culverflyer | Soaring | 22 | September 22nd 05 09:01 PM |
| Advice on sanding fibreglass | [email protected] | Home Built | 12 | April 28th 05 10:39 PM |
| Sanding composites | [email protected] | Home Built | 12 | January 31st 05 06:47 AM |
| Fear of Sanding | Stuart Grant | Soaring | 7 | January 17th 05 05:28 PM |
Threaded Mode