![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Since taking delivery of my Apis MC, the Ilec Mcu has been
intermittant on rpm. Lately it has just been "mittant" and I am getting no registration at all. The green-yellow-red rpm lights are out as well and usually the red "not charging" light is lit also, but the battery is charging just fine. Always at 13.6v. The photosensor looks ok and the reflective surfaces on the flywheel are polished up but no joy. No loose connections. Any suggestions? or are we sending the unit back to Ilec over the winter? Mark |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ilec ASR manual | Flavio Formosa | Soaring | 1 | July 9th 07 06:46 PM |
FS: Ilec SB-9 (US) | [email protected] | Soaring | 0 | December 2nd 06 11:44 AM |
FS - ILEC SB-7 | Jim Hendrix | Soaring | 0 | August 5th 05 09:08 PM |
FS-Ilec SC-7 | Glen Kelley | Soaring | 0 | March 22nd 05 03:50 PM |
Ilec SN 10 or LX 7000 | Dave Kuchenbecker | Soaring | 12 | October 23rd 03 05:05 AM |