|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
August 21st 08, 11:51 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Rivet advise please
On Aug 21, 3:21*pm, Michael Horowitz wrote:
After you cut the rivet, you do file the cut end flat, right? - Mike- When I cut a rivet with wire cutters or such I'll generally touch it to the disk sander to clean it up. But a real rivet cutter will generally leave an adequate surface finish. Unless there's a crack or a nasty barb I generally just smash the end flat. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rivet Guns | tdfsks | Home Built | 3 | July 21st 05 01:43 AM |
| Brake Rivet Problem | Jonathan Goodish | Owning | 12 | May 18th 05 08:14 PM |
| Another Rivet Question | c hinds | Home Built | 6 | October 31st 04 04:25 PM |
| WTB: Rivet 3x ,Hand Sqeezer, | Ken B | Aviation Marketplace | 0 | September 12th 04 11:49 PM |
| need link for SS rivet supplier | Charles S | Home Built | 1 | May 9th 04 02:34 AM |
Threaded Mode