![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
|
|||
|
|||
|
On Sep 6, 2:40*pm, a wrote:
Best practice without a lot of experimentation is to follow the POH, I hope I never let my rookie ass become so confident I consider deviating from the POH based on my own anecdotal experience. Next thing you know, you're an example of someone who made reasonable conclusions except for a heretofore unknown exception. There's a certain risk factor, also, I think, in deviating from one's training and, I assume in this case, longtime practice. The OP doesn't mention their typical strip, but I think they would be best served by adhering to the POH and just aiming a little further down the runway. ----- - gpsman |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carb Heat | [email protected] | Rotorcraft | 11 | April 30th 07 07:34 PM |
| Carb Heat | vlado | Piloting | 9 | January 22nd 07 04:08 PM |
| Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 08:26 PM |
| Carb heat specs? | Rich S. | Home Built | 2 | November 13th 04 05:39 PM |
| Cherokee Carb Heat. | Greg Esres | Piloting | 15 | July 29th 03 03:25 PM |