|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 29th 08, 09:31 PM
posted to rec.aviation.owning
|
|||
|
|||
mounting a PCAS on the glareshield
Has anyone found an elegant way to mount a PCAS unit like the Zaon XRX on a
compound curved glareshield? I'm using the provided Velcro in one corner, various sizes of self-adhesive bumpers in two other corners, and the fourth corner is left dangling about an inch in the air. I've had to add a bit of superglue to the pads so the adhesive doesn't start sliding around when the cockpit is hot. The unit works well with the 496 TCAS input, but I would like a more secure and level mount on the glareshield. -- Best Regards, Mike. http://flickr.com/photos/mikenoel/ http://photoshow.comcast.net/mikenoel 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PA-28 Glareshield Replacement | Marco Leon[_4_] | Owning | 8 | January 11th 08 09:33 PM |
| GPS intrference from Zaon PCAS ?? | Carl | Soaring | 9 | May 31st 07 06:12 AM |
| Glareshield Overhaul? | Mike Spera | Owning | 7 | March 24th 07 12:34 AM |
| ASW20A Glareshield needed | Tim Mara | Soaring | 0 | April 19th 04 05:17 AM |
| Glareshield renewal and TSA | Roger Long | Owning | 9 | February 27th 04 01:39 PM |
Threaded Mode