![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
It's three step process.
Wheel on the inside. Tube in between. Tire (tyre) on the outside. Use a new tube and tire, which are relatively cheap. Not worth buggering about with old stuff and "fix a flat". Haven't tried Daryll's inhalation technique. The UF/ZZ technique is good. On most gliders it's easy with a split wheel. Jim |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
FA: Aircraft tire and tube, New, 500 x 5 | [email protected] | Home Built | 1 | February 3rd 06 10:42 PM |
FA: Aircraft tire and tube, New, 500 x 5 | [email protected] | Aviation Marketplace | 1 | February 3rd 06 10:42 PM |
Puchacz Tire and Tube | [email protected] | Soaring | 1 | September 14th 04 06:17 AM |
Beech 18 Tailwheel tire tube | georg | Restoration | 4 | June 2nd 04 01:00 PM |
FS: New 1-26 Tire | Slick | Soaring | 0 | April 20th 04 01:27 AM |