|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
March 24th 09, 05:24 PM
posted to rec.aviation.soaring
|
|||
|
|||
What to use to make a mold?
On 23 Mar, 07:45, Ian Burgin wrote:
Lead has a melting temp of about 500 degrees C ... It might be worth thinking about using plumber's solder instead. It's a lead-tin eutectic alloy, which means it melts at a significantly lower temperature (183 degrees C), but still has a high density (84% that of lead). Ian 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lyc IO-540 won't make RPM. | [email protected] | Owning | 12 | December 14th 06 11:21 PM |
| How did he make this joint? | Michael Horowitz | Home Built | 4 | September 16th 05 07:14 PM |
| Fiberglass / Mold release advice requested | Mark Zivley | Home Built | 10 | April 3rd 04 12:15 AM |
| How much does a CFI make? | Peter Gibbons | Piloting | 27 | August 17th 03 03:48 AM |
| $$$'s make right? | Sydney Hoeltzli | Piloting | 9 | July 15th 03 05:54 AM |
Threaded Mode