|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#23
March 26th 09, 06:15 AM
posted to rec.aviation.soaring
|
|||
|
|||
What to use to make a mold?
At 15:03 25 March 2009, The Real Doctor wrote:
why not glue a thin layer of energy absorbing foam to each side and make yourself a very heavy cushion? And have it hit you hard in the back of the legs under high g if you plant the glider? Always a good idea to have any necessary forward of CG ballast in front of the pilot. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lyc IO-540 won't make RPM. | [email protected] | Owning | 12 | December 14th 06 10:21 PM |
| How did he make this joint? | Michael Horowitz | Home Built | 4 | September 16th 05 06:14 PM |
| Fiberglass / Mold release advice requested | Mark Zivley | Home Built | 10 | April 2nd 04 11:15 PM |
| How much does a CFI make? | Peter Gibbons | Piloting | 27 | August 17th 03 02:48 AM |
| $$$'s make right? | Sydney Hoeltzli | Piloting | 9 | July 15th 03 04:54 AM |
Threaded Mode