|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 15th 09, 10:34 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Assembling an A-65 and A&P oversite/inspections?
I'm planning on dissassembling my A-65 and sending the parts out for
inspection and repair/replacement. I would really like to assemble the engine. I understand an A&P needs to inspect as I go along. Can anyone describe at what points I would need to bring the engine to my A&P for his approval and what would he do? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Skylab Cluster Assembling 7018126.jpg | [email protected] | Aviation Photos | 0 | April 12th 07 02:42 AM |
| 100 Hour Inspections | Judah | Piloting | 26 | December 1st 06 03:30 PM |
| Pre-buy inspections | Paul Folbrecht | Owning | 12 | March 1st 04 01:27 AM |
Threaded Mode