|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 27th 09, 04:45 AM
posted to rec.aviation.soaring
|
|||
|
|||
Removing 2-33A wheel
Hey guys,
Save me some grief. I am performing my first 100 hour on our club 2-33A. To save time I am asking the steps to removing the 2-33A main wheel for bearing repack. The obvious items are remove brake cable and main axle bolt. Do you also have to remove the bracket that stabalizes the brake? What ways are you using to get the glider high enough off the ground to easily remove the wheel, etc.. Thanking you in advance, Lane 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removing RTV | John | Home Built | 6 | October 31st 06 10:07 PM |
| Removing Decals | [email protected] | Home Built | 85 | September 9th 05 11:58 PM |
| Removing Fabric | Michael Horowitz | Home Built | 3 | August 15th 05 11:25 AM |
| Removing decals | [email protected] | Owning | 8 | August 10th 05 03:55 AM |
| Wheel pants for 6.00 x 6 wheel/tire | Wallace Berry | Home Built | 2 | January 23rd 04 04:22 AM |
Threaded Mode