|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 2nd 09, 11:22 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Sheet Metal Brake in Northern California?
Does anyone have in their shop, or have complete access to, a sheet
metal brake, either a leaf/box brake or a press brake, at least 4 feet in capacity, within a 2 hour drive of Oakland, CA? I need one to bend up the longerons of my project. Contact me offline if you do. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sheet metal tab trimmer tool | [email protected] | Home Built | 2 | December 18th 07 11:17 PM |
| Deburring sheet metal and filing edges? | DL152279546231 | Home Built | 1 | April 25th 04 12:47 AM |
| Books or Videos on Sheet Metal Construction? | DL152279546231 | Home Built | 1 | March 5th 04 03:52 AM |
| Sheet metal "Nibbler" | Nolaminar | Home Built | 3 | January 24th 04 06:05 AM |
| Sheet metal shear/press brake | VideoFlyer | Home Built | 7 | October 7th 03 07:08 PM |
Threaded Mode