|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 13th 09, 10:31 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Welding and fumes
Two weeks ago I had my fuselage sandblasted and coated with two-part
epoxy. I had to get it primed prior to welding because it's going to be outside and I need the 4130 tubing to be protected. Prior to welding a tab, I used the torch to burn off the epoxy coating. I noticed lots of fumes. Is there a better way of removing the epoxy coating? Are there any other precautions I should take beside simply trying to keep my face out of the fumes? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gas Welding Aid 1 - welding clamp 1.JPG (0/1) | Stealth Pilot[_2_] | Aviation Photos | 1 | March 26th 09 07:20 AM |
| gas welding aid 2 - welding clamp 2.JPG (1/1) | Stealth Pilot[_2_] | Aviation Photos | 0 | March 26th 09 03:58 AM |
| gas welding aid 2 - welding clamp 2.JPG (0/1) | Stealth Pilot[_2_] | Aviation Photos | 0 | March 26th 09 03:57 AM |
| Gas Welding Aid 1 - welding clamp 1.JPG (1/1) | Stealth Pilot[_2_] | Aviation Photos | 0 | March 26th 09 03:50 AM |
| welding rod | Del Rawlins | Home Built | 0 | July 15th 03 11:21 AM |
Threaded Mode