|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 6th 10, 05:54 PM
posted to rec.aviation.soaring
|
|||
|
|||
Gel coat removal - water sanding vs. straight line sanding
Trying to do some work on my ship. Does anyone that reads this forum
have experience in the best way to remove gelcoat? I've got an area thats too big to hand sand on the wing that needs some work. A friend suggested I buy a water sander that continuously feeds water to the sander (similar to a pneumatic powered straight line sander). What's the best tools to safely and effectively removing the old gel? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sanding of plywood before epoxy | [email protected] | Home Built | 6 | July 15th 08 01:21 PM |
| Sanding or Waxing - PIK 20 Question | culverflyer | Soaring | 22 | September 22nd 05 09:01 PM |
| Advice on sanding fibreglass | [email protected] | Home Built | 12 | April 28th 05 10:39 PM |
| Sanding composites | [email protected] | Home Built | 12 | January 31st 05 06:47 AM |
| Fear of Sanding | Stuart Grant | Soaring | 7 | January 17th 05 05:28 PM |
Threaded Mode