![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Bear Bottoms wrote:
Bear Bottoms wrote in .250: =?utf-8?Q?=E2=99=A5Ari_=E2=99=A5_fart_stain?= wrote in : On Sat, 24 Apr 2010 23:18:16 GMT, Bear Bottoms wrote: I've already spanked Ari's butt about his lack of knowledge of aviation and aerodynamics. Novice at best. *LOL*LOL**LOL*LOL**LOL*LOL**LOL*LOL**LOL*LOL**LOL* LOL**LOL*LOL* Oh yeah, sure Bottom, I was personally involved in the development of Jetex powered subspace vehicles... really, so GFY http://www.jetex.org/models/models.html Very basic 101 aerodynamics. Childs play. BTW, tell your mentor that adjusting the center of pressure relative to the center of gravity would negate the need for trim concerns in decents or turns. Sheesh. So now you're not just a pilot but also an aircraft designer. Puh-leeze! |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ari, are you Jeffrey Bloss, libeling forger? | Mark | Piloting | 4 | April 2nd 10 12:29 AM |
Jeffrey Bloss, the coward | Jeffrey Bloss | Piloting | 0 | April 1st 10 07:44 PM |
Jeffrey Bloss, the coward | Mark | Owning | 0 | April 1st 10 01:07 PM |
Jeffrey Bloss, the coward | Mark | Piloting | 0 | April 1st 10 01:05 PM |