![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I'm trying to build an inexpensive yet effective rudder lock for an
assembled GROB 103 or TWIN ASTIR. Have tried two or three approaches but not happy with any thus far. Needs to be rugged, lightweight, and user friendly (think club environment). Any ideas? Mike |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Thanks for your input on videos | [email protected] | Soaring | 1 | February 18th 11 09:59 AM |
M-Nav Gps input ? | Mark Courtney | Piloting | 0 | January 18th 11 06:25 PM |
FAA ADS-B Out NPRM needs your input | Ron Lee[_2_] | Piloting | 24 | November 27th 07 04:06 AM |
GTX 327 serial input? | weebee | Owning | 1 | December 19th 05 01:04 AM |
Aux. Audio Input | Eugene Wendland | Home Built | 1 | April 5th 04 04:16 AM |