![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I'd like to make a stout wire cable or rope with proper TOST ring, to
have on hand should I have to tow my 15m glider from mud/soft dirt/ guano. Is a metal cable necessary/preferable, or would high breaking-strength rope be sufficient? My only experience here (Chester loam, Pegase, and stick-shift BMW) did not end well. Thanks in advance, Erik |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pulling Avionics Boxes. | brian whatcott | General Aviation | 0 | November 8th 09 04:42 PM |
Short field glider ops | [email protected] | Soaring | 5 | June 5th 09 03:21 PM |
bicycle wire - glider cable | [email protected] | Soaring | 4 | April 6th 08 05:53 AM |
Accepting cable/rope at start. | Bill Daniels | Soaring | 26 | September 6th 07 01:03 AM |
59% increase in pulling power is claimed for an unusual new rotor propeller for airplanes | Larry Dighera | Piloting | 5 | November 21st 03 02:13 AM |