|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 11th 11, 02:33 AM
posted to rec.aviation.soaring
|
|||
|
|||
LS-3 Wing Profile Templates
Rick at Sundance Aviation, Moriarty, NM is restoring an LS-3 and asked me to
post a request for profile information for the wings. Going on advice I've read on this site, I suggested to him that he pull templates off the wings, fill, gel coat, paying attention to the first 6 inches back from the leading edge, and fair the rest paying attention to waviness. So, does anyone have templates, or is the consensus to do what I described above? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| refinishing Ventus 2cm- wing profile | [email protected] | Soaring | 20 | November 6th 11 01:15 AM |
| Interesting biplane project... look at the wing profile | Bob Kuykendall | Home Built | 15 | December 5th 08 02:58 PM |
| LS3A Wing Profile Data | Robert Fidler | Soaring | 14 | October 27th 08 10:59 PM |
| Nimbus 2c wing templates | Robert Hart | Soaring | 7 | March 3rd 06 06:25 PM |
| ASW27 wing profile templates | basils27 | Soaring | 0 | June 29th 05 12:46 PM |
Threaded Mode