![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
We have run various tests with high temperatures rechargeable
batteries and PowerFLARM. I will spare you from the details, but the conclusions a 1) Recharging must take place in an area where the ambient temperature does not surpass 95 degrees Fahrenheit (35C) as otherwise the PF charging circuit will refuse to charge to prevent overheating. 2) Best rechargeable batteries to use (by far !) a Sanyo XX Battery Powered by eneloop, 2500mAh High Capacity, Ni-MH http://tinyurl.com/PF-rechargeables Make sure they are the XX 2500mAh type, Sanyo/eneloop also sells lower capacity AA's With these batteries we have repeatedly measured runtimes of over 9h at 70C (158 F) ambient with full backlight. We will update the manual accordingly. Please also remember that PowerFLARM does not charge the batteries when it is turned on. See you all soon! Urs FLARM |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
PowerFLARM Portable - Firmware Update Available - Mode C Traffic Now Supported | Paul Remde | Soaring | 24 | January 22nd 12 01:50 AM |
FS - Powerflarm Portable | Westbender | Soaring | 0 | January 9th 12 09:21 PM |
PowerFLARM Portable Units in Stock | Paul Remde | Soaring | 0 | December 16th 11 02:54 AM |
PowerFLARM | Greg Arnold[_2_] | Soaring | 6 | November 2nd 10 09:32 AM |
PowerFLARM Portable mount option | DaleKramer | Soaring | 11 | October 20th 10 03:45 PM |