|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 10th 03, 09:09 PM
|
|||
|
|||
remote oil filter for expermental
I tried to make a block off plate for my O-290 engine to connect a remote
oil filter- it worked except the oil pressure went from 90psi to 120psi- I am using champion ac filter ch-48108 & 1/2 lines- Everything is plummed right- (engine oil out to filter-in, etc) Whats different about the lycoming engine? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Frantz oil filters | Ray Toews | Home Built | 5 | October 31st 03 05:31 AM |
| Just Ordered: An Ignition Switch and Oil Filter from ACS | Larry Smith | Home Built | 30 | October 22nd 03 08:41 AM |
Threaded Mode