|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
October 15th 12, 03:26 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFLARM Brick ADS-B antenna source?
The link below is to data on the FLARM antenna at 916 MHZ. *I have a good source for those antennas. *The ADS-B antenna is shorter and for 1090MHZ. Those are the ones I can't find. The two antennas supplied with my brick are 98mm long. The only difference between them is that one is SMA and the other RP-SMA. Both of these antenna are shown on the data sheet referenced. Are you saying that some people were provided, or are being provided, with a different ADS-B antenna? If so, could this have any bearing on the unsatisfactory PCAS performance reported by some owners? Andy 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Shortening PowerFLARM Brick Antenna and GPS cables | kirk.stant | Soaring | 30 | January 29th 13 03:27 AM |
| Powerflarm Brick feedback | Ramy | Soaring | 7 | August 10th 12 01:02 AM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| PowerFLARM 'brick' progress? | Frank Paynter[_2_] | Soaring | 5 | November 13th 11 07:28 PM |
| Display for PowerFLARM brick | Andy[_1_] | Soaring | 4 | May 10th 11 02:32 PM |
Threaded Mode