![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#17
|
|||
|
|||
![]()
If you have lost height in a sink zone, your speed will need to be Lower
AFTER the sink zone. What you do in the sink is up to you (I suppose speed up.) At 12:09 12 February 2013, Naviter Info wrote: True. But while you're in sink you need to speed up. At least until you are flying the optimal speed for MC=0 for that sink. The AutoMC suggests you to slow down which is not ok any way you look at it. Andrej Kolar -- glider pilots use http://www.Naviter.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Final glide | ppp1 | Soaring | 8 | January 6th 11 02:21 PM |
Final Glide - Udo Rumpf | jsbrake[_2_] | Soaring | 23 | December 28th 10 03:40 AM |
Final Glide | Roy Clark, \B6\ | Soaring | 1 | December 23rd 10 04:45 PM |
Final Glide - JD (US) | Roy Clark, B6 | Soaring | 1 | September 19th 07 07:17 AM |
AC Williams -Final Glide | [email protected] | Soaring | 4 | January 23rd 06 04:52 AM |