![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Now, this is the current rule, please read it:
10.9.2 Finish Cylinder 10.9.2.1 A task shall include a Finish Point not more than 2 miles from the home field and a Finish Radius not greater than 2 miles. 10.9.2.2 ‡ Minimum Finish Height 10.9.2.2.1 ‡ Each task shall include a Minimum Finish Height (MFH), set by the CD at least high enough that pilots who obtain a valid finish can return to the home airfield for a normal pattern and landing. The rules committee and the SSA BOD has established this as a RULE. It now requires the CD to set "AT LEAST HIGH ENOUGH" that .......for a ""NORMAL PATTERN"" and landing. Sean Fiddler F2, or anyone else, after reading the above, is this a RULE as it reads or is it meant to be guidance as John C. says it is? It sure doesn't say guidance anywhere as I read it, but its a requirement! Tom Kelley #711. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Evan T8 questions on CN Vario | Tom Kelley #711 | Soaring | 1 | March 12th 13 09:45 PM |
Winscore finish cylinder setup | kirk.stant | Soaring | 12 | June 19th 12 08:00 PM |
Safety finish rule & circle radius | Frank[_1_] | Soaring | 19 | September 12th 07 07:31 PM |
Oil in cylinder, other cylinder issues | Jim Burns[_3_] | Owning | 2 | May 24th 07 05:26 AM |
Visulalizing the Finish Cylinder | [email protected] | Soaring | 44 | March 25th 05 02:10 PM |