|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#13
June 13th 13, 03:40 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFLARM USB 3 cables and ConnectMe to PowerFLARM through V7
My experience (core hooked up to SN10B and Oudie2, all with latest software) has been totally painless. Although I haven't declared a task in 13 years, my SN10 had no problem sending the R9 race tasks to the core on every flight last week at Moriarty. After each flight, using the Butterfly display and the same USB stick, it downloaded the latest flight in seconds, with positive feedback on the display of the status of the download. And Winscore doesn't care what else you have on your memory stick as long as the flight for the day is there.
I am EXTREMELY 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFLARM 3.0 and TIS | Andy[_1_] | Soaring | 6 | January 21st 14 09:35 AM |
| PowerFLARM 2.71...WTF? | [email protected] | Soaring | 40 | May 2nd 13 03:32 AM |
| Shortening PowerFLARM Brick Antenna and GPS cables | kirk.stant | Soaring | 30 | January 29th 13 03:27 AM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| PowerFLARM | Paul Remde | Soaring | 9 | November 6th 10 04:30 AM |
Threaded Mode