![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
On Wednesday, January 8, 1997 3:00:00 AM UTC-5, Bob Webster wrote:
Does anyone know when should carb heat be applied in a Piper Archer? I've been told (a) just for a short period (20 seconds) during the landing checklist, and (b) from the landing checklist until landing. The POH says use carb heat "as needed", and mentions using it on descent. It says not to use carb heat on approach because you may need the power in an abort. I think I would rather abort with partial power (assuming I forget to turn off the carb heat) instead of lose the engine because of carb ice, but how likely is that in a Piper? I understand that once carb heat kills the engine, it won't be restarting. When is "as needed"? The only time I've experienced carb ice was in a 152 at 5500' and at cruise speed. I've been told that the Piper Archer is not as susceptible because of the placement of the carburetor. Is that right? On Wednesday, January 8, 1997 3:00:00 AM UTC-5, Bob Webster wrote: Does anyone know when should carb heat be applied in a Piper Archer? I've been told (a) just for a short period (20 seconds) during the landing checklist, and (b) from the landing checklist until landing. The POH says use carb heat "as needed", and mentions using it on descent. It says not to use carb heat on approach because you may need the power in an abort. I think I would rather abort with partial power (assuming I forget to turn off the carb heat) instead of lose the engine because of carb ice, but how likely is that in a Piper? I understand that once carb heat kills the engine, it won't be restarting. When is "as needed"? The only time I've experienced carb ice was in a 152 at 5500' and at cruise speed. I've been told that the Piper Archer is not as susceptible because of the placement of the carburetor. Is that right? Hello Bob, My name is Joe and I just bought a Cherokee 180 archer to replace the Cherokee 140 I had that was blown away by the storm Sandy. As far has carb heat goes when I flew the 140 I only used it for the simulated engine out practice that we do. For normal landing never use it and never had problem. I have been flying the 180 for now using the numbers from 140 so far so good. Let me know if you come across anything that says we should use it for landing the P.O.H. says as need I am also confused. you can reach me at this e-mail I am based at 39N Princeton NJ and still getting used to the 180 archer. Thanks, Joe |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Carb Heat | [email protected] | Rotorcraft | 11 | April 30th 07 06:34 PM |
Carb Heat | vlado | Piloting | 9 | January 22nd 07 03:08 PM |
Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 07:26 PM |
FS: Piper J3 Carb Heat Box | Tampatexan | Aviation Marketplace | 0 | October 15th 03 01:18 AM |
FS: Piper J3 Carb Heat Box | Tampatexan | Restoration | 0 | October 15th 03 01:18 AM |