|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 5th 14, 08:01 PM
posted to rec.aviation.soaring
|
|||
|
|||
Butterfly display software - new version?
I was doing software updates on a new Brick/Core and Butterfly, and noticed the new Butterfly firmware version is 3.3. No changelog or manual yet. http://www.powerflarm.aero/index.php...ge-and-support .
PowerFLARM Core firmware is 3.4. 2D 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Butterfly Display Software 3.2 | Marc - Butterfly Avionics | Soaring | 36 | March 8th 15 08:16 PM |
| FS: Flarm Butterfly 57mm Display $150 | joesimmers[_2_] | Soaring | 0 | February 24th 14 01:27 PM |
| New Butterfly Display Software 3.2.1 released | Marc - Butterfly Avionics | Soaring | 27 | August 28th 13 02:11 PM |
| Flarm Butterfly display | [email protected] | Soaring | 10 | May 6th 13 05:40 PM |
| Updating Software on Butterfly 57 mm version 2.1 display w/o Cable? | 3Y | Soaring | 7 | December 31st 12 12:50 PM |
Threaded Mode