![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I just acquired an Eberle trailer without the spring and or strut lift assist add on that most have. If anyone has experience with this maybe you can give me some ideas on how you open and drop the support rods when alone. No problem when someone else is around, I lift, they drop the rods. Lifting it up and then going off center to drop the rod on one side and then the other seems to put to much stress on the clam shell hinge.
Thanks Bob |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
weight of an Eberle trailer | raymond herr | Soaring | 3 | November 27th 11 06:20 PM |
Eberle trailer wheel rims | Bob | Soaring | 7 | November 25th 11 05:39 PM |
Cobra trailer gas spring | Stephanie and Ed | Soaring | 4 | March 9th 07 07:09 PM |
Eberle Surge Brake Rebuild | Jim Hendrix | Soaring | 0 | June 18th 04 08:28 PM |
Ram air assist | Rich S. | Home Built | 10 | November 11th 03 05:58 PM |