A aviation & planes forum. AviationBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AviationBanter forum » rec.aviation newsgroups » Soaring
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

ClearNav Vario Spoiler Warning



 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old February 5th 15, 04:51 PM posted to rec.aviation.soaring
jfitch
external usenet poster
 
Posts: 1,134
Default ClearNav Vario Spoiler Warning

On Tuesday, February 3, 2015 at 7:45:06 AM UTC-8, firsys wrote:
In my book, warnings for take off roll and landing approach should be
audio, not on the panel. To divert your attention from outside risks a
ground loop or worse.
During takeoff, the only point at which I glance at the ASI
is after I have three axis control.
JMF

At 15:12 03 February 2015, Dan Marotta wrote:
Thanks Evan and Peter. If the winds are light enough to rig today, I'll
try it out.

Dan

On 2/3/2015 3:45 AM, Peter Purdie wrote:
Hi Dan

In case the rather shorthand answers have still left things unclear,
the system is working correctly for Gear and Spoiler Warnings
active.

In most ships you don't want to roll with spoilers open, so
have that warning active. Spoilers open, gear down, no
airspeed is a warning and SPOILERS will show on the screen.
For LS8/ASW24 or whatever where you want to roll with them
open until you have good roll control, disable the warning.

You will still get a warning (with Gear Warning enabled) if
you open spoilers with gear up. You can test the spoiler
warning function is correct by pressurising pitot to
50 knots, opening the spoilers should then give no warning
unless the gear is up.

Peter.

On Monday, February 2, 2015 at 4:11:24 PM UTC-8, Dan
Marotta wrote:
I finally completed installation of my new CNv XC vario and
am
having problems with the gear/spoiler warning logic.






In my installation, while sitting on the trailer, opening the
spoiler causes the Spoiler warning to flash and sound
off.=A0 This
happens without respect to the gear position or switch
reading.=A0
Reading the switches in the Info section of the CNv, I see
that
bot
h
switches are correctly wired and functioning (both show 0
and 1
status as appropriate).






Is it possible that this is a ground test function and I won't
know
if everything works as intended until my first takeoff?




--




Dan Marotta


Is what you are seeing a "spoilers open" warning (during
takeoff roll)
vs
.. a "gear up" warning?


--
Dan Marotta


The best warnings are from the Butterfly Vario. The Bitching Betty will say in a loud clear voice "SPOILERS ARE OPEN". Or "LANDING GEAR NOT EXTENDED". This does not leave you glancing around the cockpit wondering if it is the engine controller, the gear, the spoilers, the PDA, FLARM the oxygen control - all of which were capable of beeping in my glider. Now only the engine control and O2 control beeps. Everything else is explained to me by the B.B.
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
ClearNav Vario and XCSoar Dan Marotta Soaring 9 January 2nd 15 11:33 PM
New ClearNav CNv Vario LCD Display Paul Remde Soaring 5 June 20th 14 11:53 PM
WTB Clearnav Xcountry Vario Go Soaring Soaring 0 January 26th 14 01:29 PM
More Vario Questions - ClearNav SteveB_Z5 Soaring 4 June 12th 12 02:24 AM
ClearNav Vario Paul Remde Soaring 5 January 8th 11 11:34 PM


All times are GMT +1. The time now is 07:18 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 AviationBanter.
The comments are property of their posters.